AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Zebra scanner not scanning9/10/2023 If the scanner shows up under Unspecified (which appears as another line under Printers), contact DoTS to install the 123Scan utility found here:.If the scanner shows up under Devices and has a keyboard icon to it, go to Step 2.Once the Control Panel appears, go into Devices and Printers (highlighted).In the task bar, go to the search bar (pictured below) and type in "Control Panel".Upon plugging in your scanner, verify your computer recognizes it as an HID keyboard interface.The scanner cannot scan ones displayed on a monitor. Note: The barcodes need to be printed so that the scanner can scan them.The device appears in my "bluetooth & other devices" list in settings so I am unclear why it won't work. I have tried three separate barcode scanners (all the same model) and none of them work. Scan the Disable keypad emulation barcodeģ.Issue: I can't get any of the Motorola Symbol LS2008 barcode scanners we use in the library and archives to work on my computer. To have the proper setup for your Zebra DS2200 series barcode scanner for 2D barcodes, follow these steps:Ģ. This will pair your scanner to your computer. From the device list, click on your Zebra DS2278 model listed. Make sure that Bluetooth is enabled on your computer. This will allow your scanner to pair with your computer through Bluetooth.ģ. Once charged, unplug your scanner from the Micro USB connector and scan the general discoverable mode barcode. The LED light will be flashing green to indicate the scanner is charging.Ģ. Note that this connector is for charging your scanner only. Connect the micro USB connector to your scanner and the standard USB port to your computer or a USB wall outlet. Setting up the Zebra DS2278 barcode scanner (cordless model without cradle)ġ. The item you scanned should appear in your search results. In Retail POS, click Inventory > Item Search.Enable an automatic carriage return after a scan by scanning this barcode (also found in the Quick Start Guide packaged with your scanner):.Click the red x in the upper left-hand corner to cancel the pop-up. Note: If you are connecting the scanner to a Mac and you see a Keyboard Setup Assistant pop-up, do not click continue. Connect the cradle to a USB port on your computer.
0 Comments
Read More
Leave a Reply. |